Filter
Top Products
Operation–Scene mode
54
If you are using the Editor Librarian software, the KONTROL49 will
move to the Dump page automatically.
[15] PRELOAD
Here you can re-load any of the factory-preset scenes into the
KONTROL49’s internal memory.
You can load any of the twelve preset scenes into any scene number.
1
Hold down the [SCENE] key and press pad [15].
You will enter the Preload page, and the [SCENE] key will light.
The main display will indicate “Source” (select the preset that you
want to load), and that pad will blink.
The selectable parameter or value will blink in the main display.
2
Use the main encoder or the pads to select the preset scene that you
want to load. If you use the pads, simply press the pad for the scene
you want to load.
3
Press the OCTAVE SHIFT/CURSOR [®] key to proceed to
“Destination” (select the loading destination).
4
Use the main encoder or the pads to select the destination into which
you want to load the preset scene.
5
Press the OCTAVE SHIFT/CURSOR [®] key.
The main display will ask “Sure ?” (“Are you sure you want to load?”).
6
Press the [ENTER] key to load the preset scene.
When loading is completed, the main display will indicate “Complete”
and you will return to Play mode.
If you press the [EXIT] key, the scene name will be displayed.
If you decide to cancel, press the [EXIT] key to return to Play mode.
Never turn off the power while loading data; doing so may cause the
internal data to be damaged.
(Green)(Red)