Filter
Top Products
Operation–Setting mode
35
[10] PEDAL (Pedal assignment)
Here you can assign a MIDI message to a foot controller or expression pedal
connected to the rear panel PEDAL jack, and specify the MIDI transmission
channel.
You can assign master volume, foot pedal, portamento time, volume, pan,
expression, or control change (CC#) messages to the pedal.
1
Hold down the [SETTING] key and press pad [10].
Now you can make pedal assignments, and the [SETTING] key and
pad [10] will light. The main display indicates “Message Select” (select
the MIDI message).
2
Use the main encoder to select the MIDI message you want to assign.
NoAssign
No MIDI message will be assigned to the switch. If you choose
NoAssign, press the [ENTER] key (blinking) to apply the setting.
(☞Step 5)
MastrVol (Master Volume)
Assign master Volume. Master Volume messages [F0, 7F, 7F, 04, 01, vv,
mm, F7] (device ID fixed at 7Fh) will be transmitted. In Play mode, the
main display will indicate “MstVl--” when you operate the pedal. If
you choose MastrVol, press the [ENTER] key to apply the setting.
(☞Step 5)
FootPdl (Foot Pedal)
Foot pedal (CC#04) messages will be assigned to the pedal.
Fully advancing the pedal will transmit a value of 127, and fully
returning it will transmit a value of 0. In Play mode, the main display
will indicate “FootP--” when you operate the pedal.
PortaTm (Portamento Time)
Portamento (CC#05) messages will be assigned to the pedal.
Fully advancing the pedal will transmit a value of 127, and fully
returning it will transmit a value of 0. In Play mode, the main display
will indicate “PTime--” when you operate the pedal.
Volume (Volume)
Volume (CC#07) messages will be assigned to the pedal.
Fully advancing the pedal will transmit a value of 127, and fully
returning it will transmit a value of 0. In Play mode, the main display
will indicate “Volum--” when you operate the pedal.
Pan (Panpot)
Panpot (CC#10) messages will be assigned to the pedal.
Fully advancing the pedal will transmit a value of 127, and fully
returning it will transmit a value of 0. In Play mode, the main display
will indicate “Pan--” when you operate the pedal.
Express (Expression)
Expression (CC#11) messages will be assigned to the pedal.
Fully advancing the pedal will transmit a value of 127, and fully
returning it will transmit a value of 0. In Play mode, the main display
will indicate “Exprs--” when you operate the pedal.
CtrlChg# (Control Change)
A control change message will be assigned to the pedal. If you choose
CtrlChg#, press the OCTAVE SHIFT/CURSOR [®] key to proceed to
“Control Change Select.” (☞p.36 “Assigning a control change”)
3
Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “MIDI
Channel” (specify the MIDI channel).
4
Use the main encoder or the pads to select the MIDI channel on which
the MIDI message will be transmitted. The range is 1–16 (ch). (☞p.4
“About the trigger pad functions–Input numerical values”)
(Green)(Red)
Settin
g
mode