Filter
Top Products
Operation–Setting mode
33
CtrlChg# (Control Change)
A control change message will be assigned to the switch.
ProgChg (Program Change)
Program change messages will be assigned to switches 1/2. If you
choose ProgChg, press the OCTAVE SHIFT/CURSOR [®] key to
proceed to “MIDI Channel” (MIDI channel setting). (☞Step 6)
5
Press the OCTAVE SHIFT/CURSOR [®] key to move to “Control
Change Select” (select the control change number).
6
Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “MIDI
Channel” (specify the MIDI channel).
7
Use the main encoder or the pads to select the MIDI channel on which
the MIDI message will be transmitted. The range is 1–16 (ch). (☞p.4
“About the trigger pad functions–Input numerical values”)
8
Press the [ENTER] key.
The setting will be updated, and you will return to Play mode.
If you want to keep the changes you’ve made, save them in Scene mode.
If you turn off the power or select a different scene without saving, your
changes will be discarded. For details, see “Scene mode–[16] WRITE”
(☞p.55).
Switches 1/2 will increment or decrement the transmitted value in a
range of 0–127 for control changes, and in a range of 1–128 for program
changes.
Using the switches in two-parameter mode
If you choose two-parameter mode, you can assign damper, sostenuto, soft
pedal, portamento, or control change (CC#) messages to the switches. The
assignable messages and procedure are the same for either switch 1 or
switch 2.
1
Hold down the [SETTING] key and press pad [9].
Now you can make SW1/SW2 assignments, and the [SETTING] key
and pad [9] will light. The main display indicates “Assignment Select”
(select the assignment method).
In “Assignment Select” you can choose either one-parameter
assignment mode or two-parameter assignment mode.
2
Use the main encoder to select the assignment mode for switches 1 and
2.
Here we will select SW1/SW2.
INC-DEC (One-parameter mode)
Assign a single MIDI message to switches 1 and 2.
SW1/SW2 (Two-parameter mode)
Assign separate MIDI messages to switch 1 and switch 2.
3
Press the OCTAVE SHIFT/CURSOR [®] key to select the switch you
want to assign.
(Green)(Green)
When assigning a control change
(Green)(Green)
(Green)(Red)
Settin
g
mode