Filter
Top Products
Operation–Setting mode
22
5
Use the main encoder or the pads to input the “LSB” value. The range
is 0–127.
6
Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “MIDI
Channel” (specify the MIDI channel).
7
Use the main encoder or the pads to select the MIDI channel on which
the assigned MIDI message will be transmitted. The range is 1–16 (ch).
(☞p.4 “About the trigger pad functions–Input numerical values”)
8
Press the OCTAVE SHIFT/CURSOR [®] to proceed to “Name,” where
you can specify a name for the encoder.
9
Specify the desired name for the assignment. In Play mode, the name
you specify is shown in the sub-display. For the procedure, see
“Inputting a name” (☞p.22).
10
Press the [ENTER] key.
The setting will be updated, and you will return to Play mode.
If you want to keep the changes you’ve made, save them in Scene mode.
If you turn off the power or select a different scene without saving, your
changes will be discarded. For details, see “Scene mode–[16] WRITE”
(☞p.55).
Inputting a name
In Setting mode you can freely assign a name to the parameter you assigned
to an encoder or slider. Also, in Scene mode you can freely assign a name to
the scene you’ve assigned.
Available characters
You can input the following characters.
Moving the cursor
A cursor is shown in the main display. If the cursor is located on a character,
that character will blink. Use the OCTAVE SHIFT/CURSOR [√][®] keys to
move the cursor.
Inputting text
There are three ways to input text; using the main encoder, using the trigger
pads, or using the encoders or sliders. These three input methods are
explained below.
■ Using the main encoder to input text
Turn the main encoder to choose characters in the order of (blank), A–Z, a–
z, 1–9, 0, and symbols. Move the cursor to the position at which you want
to input a character, and use the main encoder to choose a character.
(Green)(Green)
(Green)(Green)