Filter
Top Products
Operation–Setting mode
26
Constant
The fixed velocity value you specify will be transmitted when you
strike the pad.
13
If you set “Velocity Type” to Constant, press the OCTAVE SHIFT/
CURSOR [®] key to move to “Constant” (the velocity value setting),
and use the main encoder to specify the desired velocity value in a
range of 1–127.
This constant velocity setting applies to all pads 1–8 and 9–16.
14
Press the [ENTER] key.
The settings will be updated and you will return to Play mode.
In Play mode, pads to which a control change is assigned will light
green, and pads to which a note message is assigned or for which
NoAssign is selected will be dark.
If you want to keep the new assignments, you must save them in Scene
mode. If you turn off the power or select a different scene without
saving, your changes will be lost. (☞p.55 “Scene mode–[16] WRITE”)
[4] PAD 9–16 (PAD 9–16 assignment)
PAD 9–16 assignment lets you assign MIDI messages to pads 9 through 16,
and specify the channels on which these messages will be transmitted.
1
Hold down the [SETTING] key and press pad [4].
Now you can make pad 9–16 assignments.The [SETTING] key and
pads [9] through [16] will light or blink. The main display indicates
“PAD# 09” (select the pad to assign).
The assignments that can be made for pads 9–16 and the procedure are
the same as for PAD 1–8. For details, see “PAD 1–8 assignment”
(☞p.24).
[5] Pitch Bend (Pitch Bend assignment)
Here you can assign the MIDI messages that will be transmitted when you
move the Pitch Bend controller up or down, and specify the MIDI channel
on which these messages are transmitted. If desired, you can assign separate
MIDI messages to the upward and downward ranges of movement.
Assigning a single MIDI message to the full range (up/
down)
Here’s how to assign a single MIDI message to be transmitted by the full
range (up and down) of the Pitch Bend controller. You can assign pitch bend,
master balance, aftertouch, velocity, or a control change (CC#).
1
Hold down the [SETTING] key and press pad [5].
Now you can specify the Pitch Bend assignment. The [SETTING] key
and pad [5] will light. The main display indicates “Assignment Select.”
“Assignment Select” is where you choose whether the full range of
movement (up and down) will transmit a single MIDI message, or
whether upward and downward movement will transmit separate
MIDI messages.
2
Use the main encoder to specify the Pitch Bend assignment selection.
For this example, choose UP-DOWN.
(Green)(Green)