Filter
Top Products
Operation–Setting mode
32
5
Use the main encoder or the pads to select the MIDI channel on which
the assigned MIDI message will be transmitted. The range is 1–16 (ch).
(☞p.4 “About the trigger pad functions–Input numerical values”)
6
Press the [ENTER] key.
The setting will be updated, and you will return to Play mode.
If you want to keep the changes you’ve made, save them in Scene mode.
If you turn off the power or select a different scene without saving, your
changes will be discarded. For details, see “Scene mode–[16] WRITE”
(☞p.55).
[8] VECTOR-Y (Vector-Y assignment)
Here you can assign a MIDI message to the Y-axis of the vector joystick.
In the same way as for the X-axis, you can assign a control change (CC#)
message to the Y-axis of the vector joystick.
1
Hold down the [SETTING] key and press pad [8].
Now you can specify the Vector-Y assignment, and the [SETTING] key
and pad [8] will light. The main display indicates “Message Select”
(select the MIDI message). The procedure for assigning the Y-axis of
the vector joystick is the same as for the X-axis. For details, refer to
“Vector-X assignment” (☞p.31)
[9] SW1/SW2 (SW1/SW2 assignment)
Here you can assign MIDI messages to switches 1 and 2, and specify the
MIDI transmit channel.
Switches 1 and 2 can be used either in one-parameter mode (Inc/Dec
operation) or in two-parameter mode (separate assignments for each
switch).
Using the switches in one-parameter mode
If you choose one-parameter mode, either control changes (CC#) or program
changes can be assigned to switches 1 and 2.
1
Hold down the [SETTING] key and press pad [9].
The [SETTING] key and pad [9] will light; now you can make SW1/
SW2 assignments. The main display indicates “Assignment Select”
(select the assignment method).
In “Assignment Select” you can choose either one-parameter
assignment mode or two-parameter assignment mode.
2
Use the main encoder to select the assignment mode for switches 1 and
2.
Here we will select INC-DEC.
INC-DEC (One-parameter mode)
Assign a single MIDI message to switches 1 and 2.
SW1/SW2 (Two-parameter mode)
Assign separate MIDI messages to switch 1 and switch 2.
3
Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “Message
Select” (select the MIDI message).
4
Use the main encoder to select the type of MIDI message.
NoAssign
No MIDI message will be assigned to switches 1 and 2. If you choose
NoAssign, press the [ENTER] key (blinking) to apply the setting.
(☞Step 8)
(Green)(Red)