Filter
Top Products
Operation–Setting mode
19
Setting mode
In Setting mode you can set both the Scene parameters (the assignment of
each controller, etc.) and the Global parameters (overall settings for the
entire KONTROL49).
Setting mode is divided into sixteen pages.
Hold down the [SETTING] key (the main display shows “MenuPad?”) and
press one of the pads listed below to move to the corresponding page of
parameter settings.
If you hold down the [EXIT] key and press the [SETTING] key, the main
display will show “MenuPad?” and the KONTROL49 will wait for you to
press one of the pads to select a page.
Scene parameter settings
Pad [1] through pad [15] access pages for setting Scene parameters. After
you edit these settings, you will need to save them in Scene mode.
Global parameter settings
Pad [16] access pages for setting Global parameters. These settings are saved
automatically when you exit the page or select a different scene.
About the OCTAVE SHIFT/CURSOR keys, [ENTER]
key, and [EXIT] key
In Setting mode, the OCTAVE SHIFT/CURSOR [√]/[®] keys act as cursor
keys to move between parameters.
When you hold down the [SETTING] key and press a pad to enter a page in
this mode, the key(s) will light green to indicate the direction(s) in which
you can move. You cannot move in a direction whose key is dark or lit red.
You can return to the beginning of the selected page by holding down the
[®] key and pressing the [√] key.
: You can move toward the right to another parameter
: You can move toward the left to another parameter
When you arrive at the last parameter, the [ENTER] key will blink. Press the
[ENTER] key to apply the setting and return to Play mode. If you press
[ENTER] before you arrive at the last parameter, your settings up to that
point will be applied and you will return to Play mode.
Press the [EXIT] key if you decide to discard your changes before pressing
[ENTER].
Pad No. Page Content
Pad [1] Encoder assignment Assign messages to encoders (☞p.20)
Pad [2] Slider assignment Assign messages to sliders (☞p.24)
Pad [3] PAD 1–8 assignment Assign messages to pads [1]–[8] (☞p.24)
Pad [4] PAD 9–16 assignment Assign messages to pads [9]–[16] (☞p.26)
Pad [5] Pitch Bend assignment Assign messages to Pitch Bend wheel (☞p.26)
Pad [6] Mod Wheel assignment Assign messages to Mod wheel (☞p.30)
Pad [7] Vector-X assignment
Assign messages to the left/right direction of the vec-
tor joystick (☞p.31)
Pad [8] Vector-Y assignment
Assign messages to the forward/backward direction of
the vector joystick (☞p.32)
Pad [9] SW1/2 assignment Assign messages to Switch 1/Switch 2 (☞p.32)
Pad [10] Pedal assignment
Assign messages to the connected foot controller
(☞p.35)
Pad [11] Foot SW assignment
Assign messages to connected damper pedal or
pedal switch (☞p.36)
Pad [12] Keyboard assignment Assign messages to Keyboard MIDI channel (☞p.38)
Pad [13] Main Enc assignment Assign messages to main encoder (☞p.40)
Pad [14] Message assignment
Assign messages to Message mode pad [9]–[16]
(☞p.41)
Pad [15] USB-MIDI Port setting Make USB-MIDI port settings (☞p.44)
Pad No. Page Content
Pad [16] Global setting
Pedal settings, backlight color, pad illumination
settings (☞p.46)
(GREEN)(RED)
(GREEN) (RED)
Settin
g
mode