Filter
Top Products
Operation–Scene mode
55
[16] WRITE
Here you can save the current controller assignments as a scene.
You can save twelve different scenes in the KONTROL49’s internal memory.
1
Hold down the [SCENE] key and press pad [16].
You will enter the WRITE page, and the [SCENE] key will light. The
main display will show the current scene number, and the
corresponding pad will blink.
2
Use the main encoder or the pads to select the writing-destination.
3
Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “Name”
(select a name for the scene).
4
Specify the desired name for the assignment. In Play mode, the name
you specify is shown in the main-display. For the procedure, refer to
“Inputting a name” (☞p.22).
5
Press the OCTAVE SHIFT/CURSOR [®] key or the [ENTER] key.
The main display will ask “Sure ?” (“Are you sure you want to
write?”).
6
Press the [ENTER] key to execute the Write operation.
When writing is completed, the main display will indicate “Complete”
and you will return to Play mode. The scene you wrote will be selected.
If you press the [EXIT] key, the scene name will be displayed.
If you decide to cancel, press the [EXIT] key to return to Play mode.
Never turn off the power while writing; doing so may cause the internal
data to be damaged.
(Green)(Red)
Scene mode