Filter
Top Products
Operation–Scene mode
53
[13] MIDI Channel
Here you can select the MIDI channel for the currently selected scene, and
the global MIDI channel.
Normally, the controllers of each scene will transmit messages on the MIDI
channel that you specify for each controller in Setting mode (the “Any”
setting described below). However, you can use the settings in this page to
specify a MIDI channel for the entire scene, so that messages from all
controllers will be transmitted on this MIDI channel regardless of the
settings of the individual controllers.
1
Hold down the [SCENE] key and press pad [13].
Now you can make MIDI channel settings, and the [SCENE] key and
pad [13] will light, and the [ENTER] key will blink.
The main display shows the current MIDI channel setting for the scene.
2
Use the main encoder or the pads to select the MIDI transmit channel.
(☞p.4 “About the trigger pad functions–Input numerical values”)
Any Ch (Any)
If you select “Any Ch,” messages will be transmitted on the MIDI
channel specified for each controller.
ScnCh#01–16 (Scene MIDI Channel)
MIDI messages from all controllers will be transmitted on the MIDI
channel you select here.
You can’t use the pads to select the “Any Ch” setting.
The scene MIDI channel is stored separately for each scene. If you want
to keep the changes you’ve made, save them in Scene mode. If you turn
off the power or select a different scene without saving, your changes
will be discarded. For details, see “Scene mode–[16] WRITE” (☞p.55).
3
Use the OCTAVE SHIFT/CURSOR [√]/[®] keys to move to “Global
MIDI Channel.”
4
Use the main encoder or the pads to select the global MIDI channel.
The range is 1–16 (ch).
5
Press the [ENTER] key.
The settings will be saved, and you will return to Play mode.
If you decide to cancel, press the [EXIT] key to return to Play mode.
Never turn off the power while settings are being saved. Doing so may
destroy internal data.
[14] DUMP
In the Dump page you can transfer data between the KONTROL49 and
Editor Librarian software running on your computer. You can transfer both
scene parameters and global data.
1
Hold down the [SCENE] key and press pad [14].
You will enter the Dump page, and the [SCENE] key and pad [14] will
light.
2
From the Editor Librarian software running on your computer,
transmit a MIDI Data Dump or a Dump Request to transfer data.
For details on how to transfer data to and from the Editor Librarian
software, refer to “Editor Librarian software manual” on the included
CD-ROM.
3
Press the [EXIT] key to return to Play mode.
Scene mode