Filter
Top Products
Operation–Setting mode
45
VECTOR-Y
Specify the transmission port for the Y-axis of the vector joystick.
SW1/2
Specify the transmission port for switch 1 and switch 2.
PEDAL
Specify the transmission port for a connected foot controller.
FOOT SW
Specify the transmission port for a connected damper pedal or pedal
switch.
KEYBOARD
Specify the transmission port for the keyboard.
MAIN ENC
Specify the transmission port for program change or bank select mes-
sages sent by the main encoder.
MESG A
Specify the transmission port for MIDI messages transmitted by hold-
ing down the [MESSAGE] key and pressing a pad [2]–[8], and for MIDI
Clock messages.
MESG B
Specify the transmission port for user MIDI messages specified for
each scene and transmitted by pressing pads [9]–[16].
3
Press the OCTAVE SHIFT/CURSOR [®] key to proceed to “USBPort”
(select the port).
4
Use the main encoder to select the transmission port.
A (USB Port A)
The MIDI messages assigned to the controller will be transmitted to the
computer application via port A. (See “About the KONTROL49 and
the driver ports” below)
B (USB Port B)
The MIDI messages assigned to the controller will be transmitted to the
computer application via port B. (See “About the KONTROL49 and the
driver ports” below)
5
Press the OCTAVE SHIFT/CURSOR [√] key to return to “Controller
Select,” and specify the transmission port for other controllers.
(☞Steps 2–4)
6
When you have finished making settings for each controller, press the
[ENTER] key. The settings will be updated, and you will return to Play
mode.
If you want to keep the new settings, you must save them in Scene
mode. If you turn off the power or select a different scene without
saving, your new settings will be lost. (☞p.55 “Scene mode–[16]
WRITE”)
The port settings are saved independently for each scene.
About the KONTROL49 and the driver ports
The KONTROL49’s USB-MIDI connection communicates with the computer
using 3 input ports and 2 output ports, as described below.
(Green)(Red)
The driver of the application on a computer
KONTROL49
MIDI OUT device
MIDI IN device
MIDI OUT B
MIDI IN
(MIDI OUT B Port) MIDI OUT
(MIDI IN Port) MIDI IN
(Port A) PORT A
(Port B) PORT B
(Dedicated Port) CTRL
Tr ansmitting/receiving data
dumps in native mode
Keyboard/Pad/Encoder/
Slider/Bend/Wheel/
Vector joystick/
Switch1/Switch2/
Pedal/Foot switch
MIDI OUT A
Settin
g
mode