18
2. Preparations
2-1. Installation precautions
In addition to heeding the points presented in the “Safety precautions”,
observe the following precautions as well.
Be absolutely sure to ask your dealer to do the jobs of installing and connecting the unit.
Connecting the power supply
Use within AC 100 V to 120 V.
Be absolutely sure to use only
the power cable and AC adapter
supplied with the unit.
The power cable supplied with
the unit has a 3-pin plug with a
grounding terminal.
Connect it to a 3-pole outlet
which has been connected to
ground.
Be absolutely sure to connect the ground terminal
(SIGNAL GND) at the rear of the unit to the system
ground.
Insert the DC plug as far as it will go until it locks
into position.
When the unit is not going to be used for a
prolonged period of time, turn off its power, and
disconnect the power plug from the AC outlet.
POWER
ON
SDI IN
2
3
1
SV
NM
BOOT
12V
IN
4
3
2
1
Handle carefully!
Dropping the unit or subjecting it to strong impact or
vibration may cause trouble and/or malfunctioning.
Do not allow any foreign objects to enter
inside the unit!
Allowing water, metal items, scraps of food or other
foreign objects inside the unit may cause a fire and/
or electric shocks.
Choosing the best installation location
This unit is designed for indoor use only.
Install the unit on a sufficiently strong, stable and
level surface for use.
Ensure a space of at least 100 mm (3-15/16˝)
around the front and rear vents to avoid obstructing
ventilation.
In particular, ensure sufficient space between
ventilation and wiring when using mounted in a
panel or table.
Do not install the unit in a manner in which its
cables and other accessories can be easily
damaged.
Do not install the unit in a cold place where the
temperatures will drop below 0 °C (32 °F) or in a
hot place where the temperatures will rise above
+40 °C (104 °F).
Avoid installing the unit where it will be exposed to
direct sunlight or to the hot air that is blown out from
other products.
Installing the unit in a very humid, dusty or
vibration-prone location may give rise to trouble.
Ventilation holes