Filter
Top Products
16
1. Parts and their functions
DVI OUT connector [DVI OUT]
This is the DVI-D signal output connector.
Signals with the following resolution can be output from
this connector by menu operations.
Digital RGB (vertical frequency: 60 Hz):
XGA (1024C768), WXGA (1280C768), SXGA (1280C1024),
WSXGA+ (1680C1050), UXGA (1600C1200),
WUXGA (1920C1200)
Digital RGB:
1920C1080/50P, 1920C1080/59.94P
Furthermore, the following signals can be assigned by
menu operations.
PGM, PVW, CLN, AUX, MV, KEYOUT
The connector supports the high-resolution multi view
mode so that images can be output at a high resolution
when SD has been selected as the system format.
p Analog signals cannot be output from this connector.
A DVI-I cable cannot be used.
p When the high-resolution multi view mode has been
enabled, MV signals are assigned to the DVI OUT
connector, and they cannot be assigned to the SDI
OUT 1 connector or SDI OUT 2 connector.
LAN connector [LAN] (RJ-45)
(10BASE-T/100BASE-TX)
host computer supporting IP connections to this LAN
connector are connected using LAN cables.
When a device is connected directly to the unit, use a
crossover cable (category 5 or above).
When a device is to be connected to the unit through
a hub, for instance, use a straight cable (category 5 or
above).
TALLY/GPI connector [TALLY/GPI]
(D-sub 15-pin, female, inch thread)
This connector features five contact input ports for
controlling the unit from an external device and seven
open collector output ports for outputting the tally
information and alarm information from the unit.
Cooling fan
! DC IN connector [12V IN] (DC 12V, 2.5A)
The AC adapter provided with the unit is connected to
this connector.
" Ground terminal [SIGNAL GND]
Connect this to the system’s ground.
# SERVICE switch [SV/NM]
This switch is used for maintenance purposes.
For normal operations, select the “NM” position.
$ Wire fastening fitting
An anti-theft wire available on the market can be fastened
to this fitting to prevent theft.