Filter
Top Products
15
1. Parts and their functions
1-2. Rear panel
TALLY / GPI DVI OUT DVI IN
LAN
SDI INSDI OUT
SIGNAL GND
BOOT
POWER
12 V
ON
1
1
2
4
3
234
1
2
IN
SV NM
$"
#
!
POWER switch [POWER]
When the POWER switch is set to the ON position,
the POWER indicator () lights, and the unit can be
operated.
SDI OUT connectors [SDI OUT 1, 2]
These are the HD/SD SDI signal output connectors.
The following signals can be assigned to the connector
by menu operations:
PGM, PVW, CLN, AUX, MV, KEYOUT
At the SDI OUT 1 connector, the output signals are split
into two and output through two connectors.
It is the same signal that is output.
p The OSD menu, multi view display frame, tally
information, names of the materials and audio
level meters are not displayed for the signals of the
SDI OUT 1 connector.
p When the high-resolution multi view mode is enabled,
it is not possible to assign MV signals.
SDI IN connectors [SDI IN 1 to 4]
These are the HD/SD SDI signal input connectors.
The following input modes can be set by menu
operations:
SDI IN 1, 2: Normal, DbyD
SDI IN 3, 4: Normal, DbyD, UC, Auto
The video process function can be used for all the SDI IN
1 to 4 input signals.
p The up-converter cannot be used for SDI IN 1 and 2.
p When signals differing from the system format have
been input, they are replaced with black signals.
(However, when HD has been selected as the system
format setting and DbyD or UC has been selected
as the input mode setting, SD signals with the same
vertical frequency can be input.)
DVI IN connector [DVI IN]
This is the DVI-D signal input connector.
Signals with the following resolution can be input to this
connector.
Digital RGB (vertical frequency: 60 Hz):
XGA (1024C768), WXGA (1280C768), SXGA (1280C1024),
WSXGA+ (1680C1050), UXGA (1600C1200),
WUXGA (1920C1200)
Digital RGB:
1920C1080/50P, 1920C1080/59.94P
p Analog signals cannot be input to this connector.
A DVI-I cable cannot be used.