Filter
Top Products
14
1. Parts and their functions
A bus crosspoint buttons [1 to 5]
B bus crosspoint buttons [1 to 5]
These are used to select the materials to be output to the
AUX bus, PinP bus and KEY-F/S bus.
When a button is pressed and the material allocated to
that button is selected, the indicator of the button lights.
Depending on the status of the BUS DELEGATION
button () indicators, the operation performed differs as
follows.
1. While the indicators of all three buttons are off:
When one of the crosspoint buttons is pressed, the
materials of the buses which execute the background
transitions are selected.
[B crosspoint buttons]
These are used to select the PST bus materials.
When a button from [1] to [5] is pressed, the material
assigned to the corresponding XPT1 to XPT5 is
selected.
When a button from [1] to [5] is pressed while the
SHIFT button is held down, the material assigned to
the corresponding XPT6 to XPT10 is selected.
[A crosspoint buttons]
These are used to select the PGM bus materials.
When a button from [1] to [5] is pressed, the material
assigned to the corresponding XPT1 to XPT5 is
selected.
When a button from [1] to [5] is pressed while the
SHIFT button is held down, the material assigned to
the corresponding XPT6 to XPT10 is selected.
Memo
Using the OSD menu, A/B, PGM(A)/PST(B) or PGM(B)/
PST(A) can be selected as the bus mode.
The description given above applies when the PGM(A)/
PST(B) has been selected.
For details, refer to “3-1-4. Selecting the bus mode”.
2. When the indicator of the AUX button is lighted:
When one of the crosspoint buttons is pressed, the
AUX bus material is selected.
[B crosspoint buttons]
When a button from [1] to [5] is pressed, the material
assigned to the corresponding XPT1 to XPT5 is
selected.
When a button from [1] to [5] is pressed while the
SHIFT button is held down, the material assigned to
the corresponding XPT6 to XPT10 is selected.
[A crosspoint buttons]
When a button from [1] to [5] is pressed, PGM,
PVW, KEY OUT, CLN or MV is selected respectively.
3. While the indicator of the PinP button is lighted:
When a B crosspoint button is pressed, the PinP bus
material is selected.
[B crosspoint buttons]
When a button from [1] to [5] is pressed, the material
assigned to the corresponding XPT1 to XPT5 is
selected.
When a button from [1] to [5] is pressed while the
SHIFT button is held down, the material assigned to
the corresponding XPT6 to XPT10 is selected.
4. While the indicator of the KEY-F/S button is
lighted:
When one of the crosspoint buttons is pressed, the
key fill bus or key source bus material is selected.
[B crosspoint buttons]
These are used to select the key fill bus materials.
When a button from [1] to [5] is pressed, the material
assigned to the corresponding XPT1 to XPT5 is
selected.
When a button from [1] to [5] is pressed while the
SHIFT button is held down, the material assigned to
the corresponding XPT6 to XPT10 is selected.
[A crosspoint buttons]
These are used to select the key source bus
materials.
When a button from [1] to [5] is pressed, the material
assigned to the corresponding XPT1 to XPT5 is
selected.
When a button from [1] to [5] is pressed while the
SHIFT button is held down, the material assigned to
the corresponding XPT6 to XPT10 is selected.