23
2. Preparations
2-4-2. Displaying the OSD menus on
an SDI monitor
1 Connect the SDI monitor to the unit’s
SDI OUT 2 connector.
2 Turn on the power of the SDI monitor.
3 Turn on the power of the unit.
4 Hold down the OSD ON button.
The OSD ON button indicator lights, and the OSD
menus are displayed on the SDI monitor.
If the OSD menus do not appear on the monitor,
refer to “2-5-2. How to forcibly display the OSD
menus”.
The OSD menus cannot be output from the
SDI OUT 1 connector.
If the OSD menu fails to appear on the SDI
monitor even after the above steps have been
taken, it may mean that the video format which
has been set in the unit is not the correct one.
Take the steps in the next section to change the
unit’s video format.
Refer to “Changing the video format”.
Notes
Changing the video format
If the OSD menus cannot be displayed even when the
SDI monitor has been connected to the unit, the video
format must be changed.
Follow the steps below to change the video format.
If the OSD menus can be displayed using a PC
monitor, change the video format by following the
steps in
“4-1-1. Setting the video format” (<Operations and
Settings> Operating Instructions).
1 Turn off the power of the unit.
2 Turn on the unit’s power while at the
same time holding down the button
that corresponds to the video format
supported by the SDI monitor.
Button to press at the same time Video format
[OSD ON] + A bus crosspoint [1] 1080/59.94i
[OSD ON] + A bus crosspoint [2] 1080/50i
[OSD ON] + A bus crosspoint [3] 720/59.94p
[OSD ON] + A bus crosspoint [4] 720/50p
[OSD ON] + A bus crosspoint [5] 1080/24PsF
[OSD ON] + B bus crosspoint [1] 1080/23.98PsF
[OSD ON] + B bus crosspoint [2] 480/59.94i
[OSD ON] + B bus crosspoint [3] 576/50i
3 Hold down the OSD ON button.
The OSD ON button indicator lights, and the OSD
menus are displayed on the SDI monitor.
If the OSD menu fails to appear on the SDI monitor
even after the above steps have been taken, it may
mean that the SDI monitor does not support the
unit’s SDI output format.
Check the input specifications of the SDI monitor.
Note