Filter
Top Products
31
3. Basic operations
3-2-4. Setting the border color
[2] WIPE Menu
4. Set Border Col
This item is used to select any of the following colors for the
borders.
White, Yellow, Cyan, Green, Magenta, Red, Blue, Black
3-2-5. Adjusting the border color
[2] WIPE Menu
5. Adj Border Col
This item is used to adjust the hue (H), saturation (S)
and luminance (L) of the color which has been set for the
borders.
3-2-6. Setting
[2] WIPE Menu
6. Position
This item is used to set the position where the transition is to
start for wipe patterns No.9, 10, 11, 12 and 13 using the X
and Y coordinates.
<X-Pos and Y-Pos setting range>
Inside screen area
Outside screen area
p While the [2] WIPE Menu submenu is displayed, the
items to be selected can be switched using the USER
buttons.
USER1: WIPEPos X, USER2: WIPEPos Y,
USER3: —, USER4: —
3-2-7. Registering and recalling the preset
memories
[2] WIPE Menu
7. Set To Preset
Up to four sets of wipe settings can be registered in the
preset memories.
< Registering the settings in the preset memories>
Select 1, 2, 3 or 4, and press the OSD/TIME dial.
The status currently set is now registered in the selected
preset number.
< What can be registered in the preset memories>
p Wipe patterns
p Wipe directions
p Border width of wipe
p Soft effect amount
p Border colors
p Position at which the transition starts
<Calling the preset memory settings>
What has been registered in the preset memories can be
called using the USER buttons.
p To call what has been registered, select “WIPE PRSET”
using the menu operation below.
[12] USER/FMEM Menu
1. USER1