62
6. System settings
6-1. System menu settings
6-1-1. Setting the video format
The video format of the entire system to which the unit is
connected can be set.
(QTOCV K
*K4GU/8 1HH
53 1HH
#7:#PEK 1HH
2)/#PEK 1HH
289#PEK 1HH
/8#PEK 1HH
+PKVKCN 1HH
+2#FFTGUU
5WDPGV/CUM
)CVGYC[
/#%#FFTGUU
=?5;56'//GPW
The [14] SYSTEM Menu settings cannot be changed if
“Locked” has been set using the menu item below.
[13] Operation Menu
14. SYSTEM Menu
Note
[14] SYSTEM Menu
1. Format
Select the supported format from among the options
provided below.
Supported formats
1080/59.94i 1080/50i
720/59.94p 720/50p
1080/24psf 1080/23.98psf
480/59.94i 576/50i
< How to specify the video format and then start
the system>
With the unit in the power-off status, the video format can be
specified and the system started.
Set the POWER switch to ON while holding down one
combination of the buttons listed below that corresponds to
the video format.
Button to press at the same time Video format
[OSD ON] + A bus crosspoint [1] 1080/59.94i
[OSD ON] + A bus crosspoint [2] 1080/50i
[OSD ON] + A bus crosspoint [3] 720/59.94p
[OSD ON] + A bus crosspoint [4] 720/50p
[OSD ON] + A bus crosspoint [5] 1080/24psf
[OSD ON] + B bus crosspoint [1] 1080/23.98psf
[OSD ON] + B bus crosspoint [2] 480/59.94i
[OSD ON] + B bus crosspoint [3] 576/50i
p After the POWER switch has been set to ON, keep
holding down the buttons until an image is output.
[14] SYSTEM Menu
2. HiResMV
This is used to decide whether to set the high-resolution
multi view mode. When SD has been selected as the
system’s video format setting, images can be output at high
resolution as the DVI-D output.
If this is the case, the multi view display is set for the DVI
OUT connector output.
The multi view display cannot be set for the SDI OUT
connector output.
On: The high-resolution multi view mode is enabled.
Off: The high-resolution multi view mode is disabled.
[14] SYSTEM Menu
3. 16:9SQ
This is used to set the 16:9 squeeze mode.
It can be set when SD has been selected as the system’s
video format setting.
When the 16:9 squeeze mode is selected, SD format
images are provided with a border width that factors in
cases where the images are to be converted into the 16:9
aspect ratio.
< Border width (graphical representation) when the
squeeze mode is supported>
Squeeze (4:3) 16:9