Filter
Top Products
51
4. Input/output signal settings
4-1-3. Setting the material names
[10.1] Input Menu/SDI-IN1
5. Name
[10.2] Input Menu/SDI-IN2
5. Name
[10.3] Input Menu/SDI-IN3
5. Name
[10.4] Input Menu/SDI-IN4
5. Name
[10.5] Input Menu/DVI-IN
3. Name
These are used to set the material names.
Material names can be set when “Preset” or “User” has been
selected as the material name type setting.
p The material names are merely displayed (they cannot be
set) when “Default” or “Cam Name” has been selected as
the material name type setting.
When “Preset” is selected
The materials names are set using the “type + number”
format.
Type: C, CG, CGV, CGK, PC, V, VTR, VCR
Numbers: 1 to 9
When “Preset” is selected as the material name type setting,
the “Name” item will be displayed as shown below.
0COG %)^
How to set the material names:
Press the OSD/TIME dial, and move the cursor “>” to the
position where the material type is to be selected.
Turn the OSD/TIME dial to select the material type, and
press the OSD/TIME dial to enter the selection.
Next, the cursor “>” will move to the position where the
number is to be selected. Turn the OSD/TIME dial to select
the number, and press the OSD/TIME dial to enter the
selection.
When “User” is selected
Any material names consisting of not more than 10
characters (alphanumerics and symbols which can be
expressed in ASCII codes) can be set.
When “User” is selected as the material name type setting,
the “Name” item will be displayed as shown below.
0COG #$%&^
How to set the material names:
Material names are set one character at a time.
Press the OSD/TIME dial, and move the cursor “>” to the
material name position.
Turn the OSD/TIME dial to move the blinking part to the
character input position, and press the OSD/TIME dial.
Next, the cursor “>” will move to the position where the
character is to be selected. Turn the OSD/TIME dial to select
the character, and press the OSD/TIME dial to enter the
selection.
4-1-4. Setting the freeze method
[10.1] Input Menu/SDI-IN1
2. Freeze Select
[10.2] Input Menu/SDI-IN2
2. Freeze Select
[10.3] Input Menu/SDI-IN3
2. Freeze Select
[10.4] Input Menu/SDI-IN4
2. Freeze Select
These are used to select the increment in which the SDI
input signal images are to be frozen (turned into still
images).
Frame:
The images are frozen in 1-frame increments.
Field:
The images are frozen in 1-field increments.
This is used when freezing moving images.
With interlace signals, however, diagonal lines and
moving parts appear jagged.