86
DVI-D output Digital RGB (Vertical frequency: 60 Hz):
XGA (1024M768), WXGA (1280M768), SXGA (1280M1024), WSXGA+ (1680M1050), UXGA
(1600M1200), WUXGA (1920M1200)
Digital RGB: 1080/50P, 1080/59.94P
p High-resolution multi view mode supported:
Signals are also output with a high resolution even when SD has been selected as the system
mode.
When the high-resolution multi view mode is enabled, MV is assigned to the DVI OUT
connector, and MV cannot be assigned to the SDI OUT 1 connectors or SDI OUT 2
connector
p Analog output signals are not supported.
Video delay time 1 frame (F)
p Video signals that have passed through the PinP, multi view display, DVI-D input or DVI-D
output will be delayed in each case by up to one frame.
Control I/O LAN (RJ45)
10Base-T/100Base-TX
(For IP control)
Connecting cable:
LAN cable (category 5 or above), max. 100 m (328 ft.)
p When connecting to a hub, use a straight cable.
Use a crossover cable when connecting the unit and
another device on a 1:1 basis without going through a hub.
TALLY/GPI
(D-sub 15-pin, female, inch
thread)
INPUT : 5 inputs, photocoupler sensing
OUTPUT : 7 outputs, open collector output (negative logic)
Other SERVICE switch [SV/NM] (for maintenance purposes)
Normally, this switch is used as the “NM” position.
11. Specifications