Filter
Top Products
157
MOTIF Reference
Voice Edit mode
Reference Voice mode
● [F5] Plug-in Element LFO
Basic Structure (page 47)
From this display you can set the basic LFO
parameters for modulating the pitch to create
vibrato and other special effects.
• Speed
Determines the speed of the LFO waveform. Positive
settings increase the speed and negative settings decrease
it. This is applied as an offset to the same parameter in the
original voice of the Plug-in board.
❏ Settings -64 ~ 0 ~ +63
• Delay
Determines the delay time between the moment you press
note on the keyboard and the moment the LFO comes into
effect. Positive settings lengthen the delay and negative
settings shorten it. This is applied as an offset to the same
parameter in the original voice of the Plug-in board.
❏ Settings -64 ~ 0 ~ +63
• PMod (Pitch Modulation Depth)
Determines the amount by which the LFO waveform
controls the pitch. Positive settings increase the amount
and negative settings decrease it. This is applied as an
offset to the same parameter in the original voice of the
Plug-in board.
❏ Settings -64 ~ 0 ~ +63
● [F6] Plug-in Element EQ (Equalizer)
From this display you can apply equalizer settings
to the Board voice. This is a shelving equalizer with
two bands; one for high frequencies and the other
for low frequencies.
1LowFreq (Low Frequency)
Determines the shelving point for the low frequencies.
The levels of signals below this frequency will be boosted/
attenuated by the amount set in the LoGain parameter.
❏ Settings 32Hz ~ 2.0kHz
2LowGain (Low Gain)
Determines the amount by which signals below the
LoFreq frequency will be boosted/attenuated.
❏ Settings -64 ~ 0 ~ +63
3HighFreq (High Frequency)
Determines the shelving point for the high frequencies.
The levels of signals above this frequency will be boosted/
attenuated by the amount set in the HiGain parameter.
❏ Settings 500Hz ~ 16.0kHz
4HighGain (High Gain)
Determines the amount by which signals above the HiFreq
frequency will be boosted/attenuated.
❏ Settings -64 ~ 0 ~ +63
◆ About Board Custom Voice Editing
You can edit Board Custom voices of the Plug-in Board
by using the Voice Editor software included with the
board.
n Select the Part Number of the Editor software to “1”
when using the software with the Voice mode. Also make
sure to match the basic MIDI receive channel of the
MOTIF (page 258) to the MIDI channel of the Editor
software.
The original Board Custom voices you’ve edited can be
saved and controlled from the computer.
Make sure to save the edited data to a memory card or
connected SCSI device from the MOTIF, since any edited data
in the DRAM of the Plug-in board will be lost when you turn
off the power on the MOTIF.
n For details about how to use the Voice Editor software
included with the Plug-in board, refer to the Online help
of the Voice Editor.
n Editing the above parameters may or may not have much
effect on the sound, depending on the particular Plug-in
board you've installed.
Speed=slow Speed=fast
Time
Time
Short Delay Long Delay
Key on
Key on
LowFreq
LowGain
HighGain
HighFreq
Frequency
-
+
0
1
2
3 4