Filter
Top Products
245
MOTIF Reference
Sampling Job mode
Reference Sampling mode
● [F1]-08 Fade In/Out
This Job lets you create fade-ins and fade-outs for
the sample.
• Type
Determines the type of level fade: fade-in or fade-out.
❏ Settings in (fade-in), out (fade-out)
• Length
Determines the length of the fade-in or fade-out.
When a fade-in is selected, this parameter specifies the
length of the fade starting at the specified Start point.
When a fade-out is selected, this parameter specifies the
length of the fade starting at the beginning of the fade and
ending at the specified End point.
❏ Settings 0000000~End point
● [F1]-09 Convert Freq
This Job lets you halve the sampling frequency of
the specified sample. This can be used to convert hi-
fi samples to a lo-fi sound, and reduce the sample
size by half to conserve memory.
● [F1]-10 Stereo to Mono
This Job lets you convert a stereo sample to a mono
sample.
Set the Waveform and Key Bank containing the
esired sample.
Press the [ENTER]
button to
execute the Job.
Press the [F6] (OK) button to assign the
edited sample to the specified Key Bank.
Press the [ENTER] button to execute the
operation. If you re not satisfied with the
results, change the Type and Length values
and press the [ENTER] button again. This
automatically reverts back to the original
settings and executes the operation again
with the new settings.
Press the [F5] (CANCEL) button
to cancel the operation.
Start point
Fade In
Fade Out
Length
End point
Length
Set the Waveform and Key Bank containing
the sample to be converted.
Press the [ENTER]
button to
execute the Job.
Press the [F6] (OK) button to assign the
converted sample to the specified Key Bank.
Press the [F5] (CANCEL) button
to cancel the operation.
Press the [ENTER] button to execute the operation.
If you re not satisfied with the results, change the Type
and Length values and press the [ENTER] button again.
This automatically reverts back to the original settings
and executes the operation again with the new settings.
Set the Waveform and Key Bank containing the
sample to be converted.
Press the [ENTER]
button to
execute the Job.
Press the [F6] (OK) button to assign the
converted sample to the specified Key Bank.
Press the [ENTER] button to execute the operation.
If you’re not satisfied with the results, change the Type
value and press the [ENTER] button again. This
automatically reverts back to the original settings and
executes the operation again with the new settings.
Press the [F5] (CANCEL) button
to cancel the operation.