Filter
Top Products
253
MOTIF Reference
Utility mode
Reference Utility mode
• Mic/Line
When using the A/D INPUT jacks, this determines the
input source, microphone (mic) or line.
❏ Settings mic, line
• Digital
When the optional AIEB2 board is installed, the MOTIF
features two different input connections for transferring
digital audio from an external device: coaxial or optical.
One or the other must be set; the two cannot be used at the
same time.
❏ Settings coaxial, optical
● [F2]-[SF2] I/O Output
From this display you can set parameters related to
audio output.
n The digital output resolution of the MOTIF itself is
set to 16 bit (fixed).
● [F2]-[SF3] I/O mLAN connection
From this display you can set parameters related to
connection of an optional mLAN8E (page 18). The
following display is available only when the
optional mLAN8E has been installed.
n All mLAN8E-related settings in the Utility mode
are stored only to the memory on the mLAN8E
itself, and not to the User memory of the MOTIF.
To initialize all the mLAN settings above, use the
following procedure.
[F3] Voice settings
These special voice-related settings are available only
when entering the Utility mode from the Voice mode.
● [F3]-[SF1] Voice Master Equalizer
From this display you can apply five-band
equalization to all parts of the selected voice.
• Shape
Determines whether the equalizer type used is Shelving or
Peaking. The Peaking type attenuates/boosts the signal at
the specified Frequency setting, whereas the Shelving type
attenuates/boosts the signal at frequencies above or below
the specified Frequency setting.
❏ Settings shelv (Shelving), peak (Peaking)
n For details about the shapes of the Shelving and
Peaking types, see page 168.
Specify the digital output resolution of the
optionally installed AIEB2 board (page 19).
❒ Settings 20bit, 24bit
Set the output gain of each jack.
❒ Settings 0dB, +6dB, +12dB, +18dB
Vendor Name
For details on this parameter,
refer to the owner’s manual of
the mLAN8E.
Nickname
[SF4] button[EXIT] button
Assign a nickname for the connection. For specific
instructions on naming, see Basic Operation on page 75.
For details about the Nickname parameter, refer to
the owner’s manual of the mLAN8E.
Press the [ENTER] button to
actually set the value.
Set the Word Clock. For
details, refer to the owner’s
manual of the mLAN8E.
[SF5] button[EXIT] button
Press the [ENTER] button to
actually initialize the mLAN settings.
Q (Frequency Characteristic)
Gain
Freq
(Frequency)
0