Filter
Top Products
246
MOTIF Reference
Sampling Job mode
Reference Sampling mode
• Type
Determines which channel, or both channels, of the stereo
sample will be converted to a mono sample.
❏ Settings
L+R>mono
The left and right channels of the stereo sample are mixed
and converted to a mono sample.
L>mono
The left channel of the stereo sample is converted to a
mono sample.
R>mono
The right channel of the stereo sample is converted to a
mono sample.
● [F1]-11 Loop-Remix
This Job lets you automatically cut the sample into
separate “slices” and randomly rearrange the slices
for special effects and unusual rhythmic variations.
A variety of audio transform operations are also
included for even greater changes in the sound.
• Type
Determines the degree to which the looped portion of the
sample will be sliced.
❏ Settings 1~4
• Variation
Determines how the original sample is varied by the this
Job.
❏ Settings
normal1, 2
These settings slice and rearrange the sample data,
without performing any other audio changes.
r
everse1, 2
In addition to slicing and rearranging, these settings
reverse the playback of some of the slices.
● [F1]-12 Slice
This Job lets you divide the sample into separate
“slices,” the number of which is determined by the
note length (with Measure, Meter, and SubDivide).
When entering this Job from the Song/Pattern
mode, note data for playing the slices in sequence is
also created. (Keep in mind that the results of this
Job vary depending on the previously selected
mode: Voice/Performance or Song/Pattern.)
With the exception of the parameter below, all
parameters and settings are the same as in the Slice
display of the Sampling Record mode (page 238).
• Lowest Key
Specifies the lowest key number from which the sliced
samples are ordered.
❏ Settings C - 2 ~G8
n In the Slice display of the Sampling Record mode
(page 238), this parameter is fixed to “C-1” for the
MOTIF6, “E0” for the MOTIF7, “A-1” for the
MOTIF8, and cannot be set.
Set the Waveform and Key Bank containing the
sample to be Loop-remixed.
Press the [ENTER]
button to
execute the Job.
Press the [F6] (OK) button to assign the
Loop-remixed sample to the specified Key Bank.
Press the [ENTER] button to execute the operation.
If you re not satisfied with the results, change the Type
and Variation values and press the [ENTER] button again.
This automatically reverts back to the original settings and
executes the operation again with the new settings.
Press the [F5] (CANCEL) button to
cancel the operation.
Set the Waveform and Key Bank containing the
sample to be sliced.
Press the [ENTER]
button to execute
the Job.
Press the [F6] (OK) button to assign the sliced
sample to the specified Key Bank.
Press the [ENTER] button to execute the operation. If
you re not satisfied with the results, edit the various
parameters and press the [ENTER] button again. This
automatically reverts back to the original settings and
executes the operation again with the new settings.
Press the [F5] (CANCEL) button to
cancel the operation.