Filter
Top Products
195
MOTIF Reference
Song Job mode
Reference Song mode
● [F2]-02 Modify Velocity
This job alters the velocity values of the specified
range of notes, letting you selectively boost or cut
the volume of those notes.
Velocity changes are calculated as follows:
Adjusted velocity
= (original velocity x Rate) + Offset.
If the result is 0 or less, the value is set to 1. If the
result is higher than 127, the value is set to 127.
• Set All
Sets the velocities of all target notes to the same fixed value
(1 to 127). When set to “OFF” the Set All parameter has
no effect. When set to a value other than “OFF” the Rate
and Offset parameters are unavailable and appear as “***”
on the display.
❏ Settings OFF(0), 001~127
• Rate
Determines the percentage by which the target notes will
be shifted from their original velocities.
Settings below 100% reduce the velocities, and settings
above 100% increase the velocities proportionately. When
the Set All parameter is not “OFF” this parameter appears
as “***” and cannot be changed.
❏ Settings 000% ~ 200%, ***
• Offset
Adds a fixed value to the Rate-adjusted velocity values.
A setting of 0 produces no change. Settings below 0 reduce
the velocities, and settings above 0 increase the velocities.
When the Set All parameter is not “OFF” this parameter
appears as “***” and cannot be changed.
❏ Settings -127 ~ +127, ***
● [F2]-03 Modify Gate Time
This job alters the gate times of the specified range
of notes. Gate time changes are calculated as
follows:
Adjusted gate time
= (original gate time x Rate) + Offset.
If the result is 0 or less, the value is set to 1.
• SetAll
Sets the gate times of all target notes to the same fixed
value. When set to “OFF” the Set All parameter has no
effect. When set to a value other than “OFF” the Rate and
Offset parameters are unavailable and appear as “***” on
the display.
❏ Settings Off (0), 0001 ~ 9999
• Rate
Determines the percentage by which the gate time of the
target notes will be changed.
Settings below 100% shorten the notes, and settings above
100% lengthen the notes proportionately. When the Set
All parameter is not “OFF” this parameter appears as
“***” and cannot be changed.
❏ Settings 000% ~ 200%, ***
• Offset
Adds a fixed value to the Rate-adjusted gate time values.
A setting of 0 produces no change. Settings below 0
shorten the gate time, and settings above 0 lengthen the
gate time. When the Set All parameter is not “OFF” this
parameter appears as “***” and cannot be changed.
❏ Settings -9999 ~ +9999, ***
Track
Range
Original velocity
Rate = 50%
Rate = 150%
(Vel)
(Vel)
(Vel)
96 64 48 32
48 32 24 16
127 96 72 48
Original velocity
Offset = -20
Offset = +20
(Vel)
(Vel)
(Vel)
96 64 48 32
76 44 28 12
116 84 68 52
Track
Range
Original gate time
Gate time rate = 50%
Gate time rate = 150%
(Gate)
(Gate)
(Gate)
32 32 32 48
16 16 16 24
48 48 48 72
Original gate time
Offset = -20
Offset = +20
(Gate)
(Gate)
(Gate)
32 32 32 48
12 12 12 28
52 52 52 68