6-4 Removing and Replacing Parts
EN
If an optional duplexer is installed:
1 Slide the rear section of the
duplexer away from the printer.
2 Remove the rear section of the
duplexer by lifting and rotating the
rear section to clear all of the tabs in
the grooves, as illustrated.
3 Unplug the power cord and
disconnect any cables.
4 Remove the cable tray by lifting it
out of position, as illustrated.
5 Reverse these steps to install the
cable tray and the rear section of
the duplexer. Make sure the cable
tray is properly installed and the
cables are routed through the left
side.
