A SERVICE OF

logo

7-32 Troubleshooting
EN
50.x FUSER ERROR
A Fuser error has
occurred.
X Description
1 Low Fuser temperature.
2 Fuser warm up service.
3 High Fuser temperature.
4 Faulty Fuser.
5 Inconsistent Fuser.
1. Turn the printer off for a
minimum of 20 minutes to
clear the error.
2. Reseat the Fuser.
3. Turn the power off and
remove the Fuser. Check
continuity between
connectors J1307-1 and
J1307-2. If there is no
continuity, replace the
Fuser.
4. Check continuity
between connectors
J1308-3 and J1308-1
with the Fuser removed.
If there is no continuity,
replace the Fuser.
Figure 7-3 Fuser Connectors
Table 7-6. Numerical Printer Messages (continued)
Control Panel
Message
Event
Log
Message
Explanation Recommended
Action