A SERVICE OF

logo

Open as PDF
next previous
6-54 Removing and Replacing Parts
EN
Tray 2 Shaft
1 Remove the Top Cover (page 6-12), Left and Right Side Covers
(page 6-23), Pickup Gear Assembly (page 6-36), and Paper
Handling PCA (page 6-31).
2 Remove the spring from the gear on the left side of the shaft.
3 Align the solenoid arm (B) (see Figure 6-43) with the gap in the
gear (on the left side of the printer).
4 Press the release tabs (A) outward, and slide the gear off the
shaft.
5 Remove the bushing on the right side of the shaft by lifting the
release tab and sliding it off the shaft.
6 Slide the shaft to the right, then angle it out of the chassis.
Figure 6-43 Tray 2 Shaft (left side view of printer)
Item Explanation
A
Release Tabs
B
Solenoid Arm
C
Gap