A SERVICE OF

logo

6-30 Removing and Replacing Parts
EN
Fuser
1 Remove the Rear Door and Rear output bin (page 6-10).
2 Facing the back of the printer, remove the two machine screws
holding the Fuser in the chassis. See Figure 6-22.
3 Using a small, flat bladed screw driver, lift at ā€œDā€ to disengage the
Fuser Assembly detents. Grasp the green Pressure Release
Handles and pull the Fuser out of the chassis.
Note The fuser power connection is on the left side of the assembly.
Figure 6-22 Fuser (rear view of printer)
Item Explanation
A
Pressure Release Handles
B
Fuser
C
Screws
D
Screw driver lifting point