6-24 Removing and Replacing Parts
EN
Tray 1 Inner Cover
1 Remove the Top Cover (page 6-12), Left and Right Side Covers
(page 6-23), and Front Cover and Tray 1 (page 6-18).
CAUTION Be sure to locate the Paper Sensor Flag on the left side of the Cover,
before proceeding to step 3. It rests in an indention in the left side of
the chassis and is easily broken. See Figure 6-16.
2 The Tray 1 Inner Cover is a plastic tray located at the top front of
the printer. Remove the two self-tapping screws, (A) in Figure
6-17, holding the Cover to the front of the chassis.
Figure 6-16 Tray 1 Inner Cover Flag (view from inside printer, left side)
3 Facing the front of the printer, slip the Cover off of the locating
pins.
Hint To install a self-tapping screw, first turn it to the left until it clicks,
indicating the threads are seated. Then, turn it to the right to tighten.
Do not over-tighten. If a self-tapping screw-hole becomes stripped,
repair of the screw-hole or replacement of the affected assembly is
required.
