A SERVICE OF

logo

Open as PDF
next previous
6-52 Removing and Replacing Parts
EN
Tray 1 Shaft
1 Remove the Top Cover (page 6-12), Left and Right Side Covers
(page 6-23), Pickup Gear Assembly (page 6-36), and Paper
Handling PCA (page 6-31).
2 Raise the green center handle of the Registration Assembly.
3 Remove the plastic collar on the right, outside the chassis, by
pulling outward on the collar’s release tab and sliding the collar off
the shaft.
4 Release the collar on the inside right of the chassis by pulling UP
on the release tab, and sliding the collar to the left. See Figure
6-42.
Figure 6-42 Tray 1 Shaft (right side view of printer)
Item Explanation
A
Locking Tab