A SERVICE OF

logo

EN
Control Panel Menus
3-21
MOPIER
MODE=STANDARD
STANDARD
ENHANCED
OFF
Determine how the mopier functions
behave. This item appears only when there
is at least 8 MB of memory or an optional
hard disk is installed.
STANDARD
:
This option is available if there
is either a hard disk installed or a RAM disk
configured in memory. This option uses I/O
data stored in printer memory for
generating multiple original prints. (All
copies will print at the same speed as the
first copy.)
ENHANCED
:
This option is available if there
is a hard disk installed and at least 8 MB of
memory. This option uses engine video
data for printing multiple original prints and
should print all copies after the first at the
printer’s maximum speed.
OFF
:
Disables the mopier functions. (The
printer will not spool any jobs to the hard
disk.)
When the mopier mode is changed, any
downloaded resources (such as fonts or
macros) will need to be downloaded again,
unless they are stored on an optional hard
disk or flash DIMM.
RAM DISK=OFF OFF
ON
AUTO
Determine how the RAM disk is configured.
This item appears only if there is no
optional hard disk installed and the printer
has at least 8 MB of memory.
OFF
:
The RAM disk is disabled.
ON
:
The RAM disk is enabled. Configure
the amount of memory to be used through
the following item:
RAM DISK SIZE
.
Note
If the setting is changed from
OFF
to
ON
or
from
OFF
to
AUTO
, the printer will
automatically reinitialize when it becomes
idle.
Table 3-8. Configuration Menu (continued)
Item Values Explanation