A SERVICE OF

logo

EN
Troubleshooting the Printing System
7-37
68 NVRAM FULL
CHECK SETTINGS
An error occurred in the
printer’s nonvolatile
memory (NVRAM) and one
or more printer settings
has been reset to its
factory default.
1. Print a Configuration
Page and check the
printer settings to
determine which values
have changed.
2. Hold down
[Cancel
Job]
while turning the
printer on. This will clean
up the NVRAM by
removing old areas that
are not being used.
69.x
PRINTER ERROR
A temporary printing error
occurred.
X Description
0 The duplex mechanism
has failed.
1 The duplex side adjust
has failed.
1. Turn the printer off, then
turn the printer on.
2. Reseat Duplexer.
Table 7-6. Numerical Printer Messages (continued)
Control Panel
Message
Event
Log
Message
Explanation Recommended
Action