7-76 Troubleshooting
EN
Interface Troubleshooting
This section provides an overview of the printer’s interface
requirements.
Communications Check
Note Communication problems are normally the customer’s responsibility.
Time spent attempting to resolve these problems may not be covered
by the product’s Hewlett-Packard warranty.
Refer the customer to the network administrator for assistance in
troubleshooting network problems.
If the printer is not connected to an MS-DOS-based host, proceed to
the Communications Checks table in this section.
Test Message
After the printer is installed, verify communications between the
printer and the IBM-compatible computer. Enter the following at the
DOS prompt:
C:\DIR>LPT1 Enter (for printing to parallel port #1)
The printer should print a directory listing of the C: \ directory.
EIO Troubleshooting
The JetDirect Configuration Page shown in Figure 7-7 contains
valuable information regarding the current status of the EIO
accessories. Before attempting to troubleshoot a network problem or
notifying your network consultant of a problem, always print a
Configuration Page.
See the
HP JetDirect Print Server Software Installation Guide
for
detailed explanations of network issues.
