A SERVICE OF

logo

Open as PDF
next previous
6-42 Removing and Replacing Parts
EN
Tray 2 Roller
1 Remove the Paper Tray, and tilt the printer backwards, with the
front of the printer facing up.
2 Depress the tab (A) on the right side cam, and slide the cam and
the bushing to the right.
3 Rotate the D-Roller 180
o
and remove it from the shaft.
Figure 6-33 Tray 2 Roller (bottom view of printer)
Hint To reassemble the roller, orient the pin on the D-Roller so that it lines
up with the hole on the right side cam. Slide the cam toward the Roller
until the tab snaps into place.
Item Explanation
A
Tab is behind this cam.
B
Cam
C
Bushings