A SERVICE OF

logo

Open as PDF
next previous
6-48 Removing and Replacing Parts
EN
Figure 6-38 DC Controller Assembly (long screws)
5 Remove the two screws (A) (Figure 6-38) located at the back of
the DC Controller Assembly, inside the chassis. These are long
screws; their position requires the use of a magnetized
screwdriver.
6 Facing the rear of the printer, remove the two spring-loaded
machine screws closest to the ground wire removed in step 4
above. Remove the spring-loaded machine screw closest to you
on the right side.
7 Slide the DC Controller Assembly out of the rear of the chassis.
Item Explanation
A
Long Screws