EN
User Installable Accessories
6-5
Checking Memory Installation
Follow this procedure to verify that DIMMs are installed correctly:
1
Check that the printer’s control panel displays
READY
when the
printer is turned on. If an error message appears, a DIMM might
have been incorrectly installed. Check the printer messages.
2
Print a new configuration page.
3
Check the memory section on the configuration page and
compare it to the configuration page printed before the DIMM
installation. If the amount of memory has not increased, the DIMM
might not be installed correctly (repeat the installation procedure),
or the DIMM might be defective (try a new DIMM).
4
See Chapter 7, Troubleshooting, for additional information.
Installing EIO Cards / Mass Storage
Turn off the printer before installing the EIO card or mass storage
device. Slots will accommodate either type of device.
For more information, see Appendix C in the User’s Guide.
