Filter
Top Products
103
Connecting External MIDI Devices
Try Playing the RD-700SX from an external MIDI Device.
921
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
fig.06-06e
1.
Before starting the connection procedure, make sure that
the power to all devices has been turned off.
2.
After reading “Connecting the RD-700SX to External
Equipment” (p. 21), connect an audio device/system or
headphones.
3.
Connect the external MIDI device with the MIDI cable as
shown in the figure above.
4.
As described in “Turning On the Power” (p. 23), turn on the
power of each device.
Set the RD-700SX’s receive channel to match the external MIDI
device’s transmit channel.
For instructions on setting the RD-700SX’s Receive channel, refer to
“Setting the Receive Channel (Receive Channel)”
(p. 92).
When both channels are matched, playing the external MIDI device
produces sounds from the RD-700SX’s sound generator.
For instructions on how to set the transmit channel of the
external MIDI device, refer to the owner’s manual for your
external MIDI device.
Transmitting Bank Select (Controller Number 0, 32) and Program
Change messages from the external MIDI device to the RD-700SX
allows you to switch Setups and Tones.
The MIDI messages transmitted by the external MIDI device will be
received by the RD-700SX to select Setups as shown in the following
table.
When switching setups, you must match the MIDI channel of the
transmitting device with the RD-700SX’s Control channel (p. 81).
When switching the tones in each part, match the MIDI channel of
the transmitting device with the RD-700SX’s Receive channel.
However, when the Control channel and the Receive channel are
both set to the same channel, the Control channel takes priority, and
Setups are switched.
The MIDI messages transmitted by the external MIDI device will be
received by the RD-700SX to select Tones as shown in the following
table.
For details on the SRX Series Tones, refer to the owner’s manual
for the SRX Series Wave Expansion Board and p. 36.
Playing the RD-700SX’s
Internal Sound Generator
from an External MIDI
Device
Making Connections
Setting the Channels
MIDI IN
MIDI OUT
MIDI Sequencer
RD-700SX
Selecting RD-700SX Sounds from
an External MIDI Device
Switching Setups
Number
Bank Select Program Change
Number
MSB LSB
1–100
085 0 1–100
Switching Tones
Group Number Bank Select Program
Change
Number
MSB LSB
PIANO 001–020 087 064 001–020
E.PIANO 021–041 087 065 001–021
CLAV/
MALLET
042–062 087 066 001 - 021
ORGAN 063–072 112 0 001–010
073–092 087 067 001–020
STRINGS 093–114 087 068 001–022
PAD 115–134 087 069 001–020
GTR/BASS 135–172 087 070 001–038
BRASS/
WINDS
173–196 087 071 001–024
VOICE/
SYNTH
197–218 087 072 001–022
Rhythm Set 219–223 086 064 001–005
RD-700SX_e.book 103 ページ ２００６年３月２３日 木曜日 午後２時５２分