Filter
Top Products
67
Using the RD-700SX As a Master Keyboard
Portamento is a function that causes the pitch to change smoothly
from one note to the next note played.
The Portamento Time setting determines the time for the change in
pitch when the portamento effect is applied to the sound. Higher
settings will cause the pitch change to the next note to take more
time.
Set the change in volume that occurs in response to the force used to
play the keyboard (velocity) and the maximum value of the change.
This makes settings related to the pitch of each Part.
1 cent = 1/100 semitone
This sets the amount of pitch change that will occur when you move
the Pitch Bend lever (4 octaves).
This sets the depth of the effect when the Modulation lever is tilted.
These settings determine whether the external MIDI device is
controlled (ON), or not (OFF) by the pedals connected to each
PEDAL jack, the slider, the Modulation lever, and the Bender.
You can make two types of settings here, the Control Change
message to be transmitted and the value for the Control Change.
Smoothly Changing the Pitch
(Portamento)
Parameter
TX CC# Value
POR (Portamento Switch)
CC65 ---, OFF, ON
P.T (Portamento Time) CC5 ---, 0–127
Setting the Change in Volume
According to the Force Used to
Play the Keyboard
(Velocity Sensitivity/Max)
Parameter
Value Description
SNS
(Velocity
Sensitivity)
-63–+63 This setting determines how the vol-
ume changes in response to the ve-
locity.
The volume is increased as the key-
board is played with greater force
when a positive Value is used; when
a negative value is selected, the vol-
ume decreases as the keys are
played with greater force. If this is
set to “0,” the volume will not be af-
fected by the strength of your play-
ing on the keyboard.
MAX
(Velocity Max)
1–127 Maximum velocity value for the
corresponding key.
Lowering this value will produce
softer notes even if you play the key-
board strongly.
Changing the Pitch
(Coarse Tune/Fine Tune)
Parameter
RPN Description Value
C.T
(Coarse Tune)
00H/
02H
Sets the sound’s
pitch in semitone
units.
--- (OFF),
-48– +48
(+/- 4 octaves)
F.T
(Fine Tune)
00H/
02H
Sets the sound’s
pitch in units of
one cent.
--- (OFF),
-50– +50
(+/- 50 cents),
Setting the Range for the Change
in Pitch with the Bender
(Bend Range)
Parameter
RPN Value
B.R (Bend Range)
00H/00H --- (OFF), 0–48
(semitone)
Setting the Amount of Modulation
Applied (Modulation Depth)
Parameter
RPN Value
M.D (Modulation Depth)
00H/05H --- (OFF), 0–127st
Turning Each Controller On and
Off
Parameter
Description Value
Dp
Damper pedal ON, OFF
F1 Pedal connected to the FC1 jack
F2 Pedal connected to the FC2 jack
PB Pitch Bender
Md Modulation Lever
UP1 Control Slider (UP1)
UP2 Control Slider (UP2)
LW1 Control Slider (LW1)
LW2 Control Slider (LW2)
Transmitting the Control Change
(USER CC/USER CC Value)
Parameter
Value
CC1 (User CC1)
OFF, 0–127
Value (User CC1 Value)
CC2 (User CC2)
Value (User CC2 Value)
RD-700SX_e.book 67 ページ ２００６年３月２３日 木曜日 午後２時５２分