Filter
Top Products
17
Getting Ready
4
Use the Installation Tool supplied with the Wave Expansion Board to
turn the holders in the LOCK direction, so the board will be fastened
in place.
fig.00-05e
5
Use the screws that you removed in step 2 to fasten the cover back in
place.
After installation of the Wave Expansion Boards has been completed, check to
confirm that the installed boards are being recognized correctly.
fig.00-06p
1
Turn on the power, as described in “Turning On the Power” (p. 23).
2
The name of the installed wave expansion board is displayed for as
long as EXPANSION [A] or [B] is held down.
The number of tones and Rhythm Sets contained in the expansion board is
displayed.
The example here depicts what you would see if the SRX-02 “Concert Piano” Wave
Expansion Board were installed in the SRX A slot.
fig.00-07g
By releasing the button, you go back to the previous screen.
Checking the Installed Wave Expansion Boards
LOCK
Installation tool
2
“Selecting Wave Expansion
Board Tones” (p. 35).
If “------” appears next to the
name of the slot in which the
b
oard was installed, it may be
that the wave expansion board
is not being recognized
properly. Use the procedure in
“Turning Off the Power” (p.
24) to turn the power off, then
reinstall the wave expansion
b
oard correctly.
RD-700SX_e.book 17 ページ ２００６年３月２３日 木曜日 午後２時５２分