Filter
Top Products
76
Making Detailed Settings for the ONE TOUCH Tones
You can make changes in tones by adjusting the settings of the
elements.
Decay Time Offset:
The time it is to take following the attack for the volume to decrease.
Cutoff Offset:
Adjusts how much the filter is opened.
Release Time Offset:
The time it takes after the key is released for a sound to become
inaudible.
With certain tones, the effect may be difficult to distinguish.
This restores the One Touch E. Piano settings to their initial
conditions.
1.
In Step 3 of the Piano Edit settings instructions
(p. 73), select “5. Initialize” and press [ENTER].
To cancel the Initialize, press [EXIT].
2.
Press [ENTER].
The confirmation message appears.
3.
Press [ENTER] once again.
The ONE TOUCH [PIANO] tones are initialized.
You can make more detailed settings to fashion just the Tones you
want using the E.piano Tone selected by pressing ONE TOUCH
[E.PIANO] (p. 32).
This function is called “E.Piano Edit.”
The settings made in E.Piano Edit are stored to ONE TOUCH
[E.PIANO].
When ONE TOUCH [E.PIANO] is pressed, all settings other
than the E.Piano Edit settings are switched to their status at the
time the RD-700SX’s power was turned on. Store any
arrangements of settings that you want to keep in Setup (p. 58).
1.
Press [F1] in the ONE TOUCH [E.PIANO] screen to
select the type you want to set.
2.
Press [F2].
fig.04-g07-1
3.
Press CURSOR [ ]/[ ] to switch screens, and
press CURSOR [ ]/[ ] to move the cursor to
the parameter to be set.
4.
Press [INC]/[DEC] to set the value.
5.
If you want to save the setting, press [F1 (WRITE)].
The confirmation message appears. Press [F1 (WRITE)] to save
the settings. If you want to cancel, press [EXIT].
6.
When you finish making settings, press [EXIT].
You are returned to the ONE TOUCH [E.PIANO] screen.
Changing Sound Characteristics
(Tone Modify)
Parameter
Value Description
Decay Time
(Offset)
-64–+63 The time it takes for the volume to
fall increases as the value is raised;
lowering the value decreases the
decay.
Cutoff
(Offset)
Higher values brighten the sound;
lower values make the sound seem
darker.
Release
Time
(Offset)
Higher values produce longer decay;
set lower values for a clear-cut
sound.
Restore the settings to initial
conditions (Initialize)
Making Detailed Settings
for the E.Piano Tones
(E.Piano Edit)
Making the settings
RD-700SX_e.book 76 ページ ２００６年３月２３日 木曜日 午後２時５２分