Roland RD-700SX Musical Instrument User Manual


 
110
Troubleshooting
Cannot Select
the Tone Wheel
Screen
The screen is displayed by selecting a
Organ Tone (TW-Organ 1–10) for any of
the UPPER1, UPPER2, or LOWER Parts
in the Tone screen, and then pressing
CURSOR [ ] (p. 53).
Key Range
Settings Not
Effective
Is [SPLIT] set to OFF?
• Key Range goes into effect when
[SPLIT] set to ON (p. 66, p. 69).
Tempo Doesn’t
Change
Is the System Clock Source setting in Edit
mode set to “MIDI”?
• When you want to perform using the
RD-700SX’s tempo, set this to “INT”
(p. 81).
Pitch is Odd
Depending on the Tone selected, pitches
played in certain registers will be
changed and played at other pitches.
Is Coarse Tune, Fine Tune, or Stretch
Tune set for any specific Part?
Check the following settings.
• Tone Info Course Tune, Fine Tune
(p. 71)
• Stretch Tune settings in Edit mode
(p. 82)
• C.T and F.T setting in External screen
(p. 67)
Has the RD-700SX gone out of tune?
Check the following settings.
• System Master Tune settings in Edit
mode (p. 27).
• System Temperament settingsin Edit
mode (p. 82)
• Micro Tune settings in Piano Edit (p. 75)
Has the pitch been changed by pedal
operations or by Pitch Bend messages
received from an external MIDI device?
Sound is Cut
Off
When you try playing more than the
maximum 128 voices simultaneously,
sounds currently being played may be
cut out.
• Increase the Voice Reserve settings for
the Parts you do not want to have cut
off (p. 92).
Sound Keeps
Playing When
Key is Pressed
Is the pedal polarity reversed?
• Check the System Pedal Polarity
settings in Edit mode (p. 81).
Exclusive
Messages
Cannot Be
Received
Is the Device ID number of the
transmitting device matched to the RD-
700SX’s Device ID number?
• Check the System Device ID settings in
Edit mode (p. 81).
Problem
Check/Solution
Song Data Not
Played Back
Correctly
Is the Receive GM/GM2 System On
Switch set to ON?
• Set the System Rx GM System On or
System Rx GM2 System On to ON in
Edit mode (p. 82).
Are you playing back GS Format song
data?
• Once the RD-700SX receives a GS Reset
message, it then is enabled for GS
Format. This permits playback of music
files bearing the GS logo (GS music
files). However, data created
exclusively for the Sound Canvas
Series may not play back properly on
the RD-700SX.
Pedal function
is not affected
Is the System Pedal Mode setting in Edit
mode set to “SYSTEM”?
• Set this to “SETUP” (p. 80).
Problem
Check/Solution
RD-700SX_e.book 110 ページ 2006年3月23日 木曜日 午後2時52分