Filter
Top Products
70
Making Detailed Settings for Tones
These settings determine whether the pedals connected to each
PEDAL jack (DaMPER, FC1, FC2), the Modulation lever, the Bender,
and the Slides are used to control the Parts (ON), or not (OFF).
You can make more detailed settings to the tones assigned to each of
the Internal parts.
In certain selected Tones, there may be parameters that cannot
be changed.
1.
In the Tone screen, press [F1(Tone Info)].
The [F1] is lit, and the Tone Info screen appears.
fig.04-03g
2.
Press CURSOR [ ]/[ ] to switch screens, and
press CURSOR [ ]/[ ] to move the cursor to
the parameter to be set.
fig.04-04g
3.
Press [INC]/[DEC] to set the value.
4.
When you finish making settings, press [F1],
extinguishing its indicator.
You are returned to the Tone screen.
The following parameters cannot be changed when the selected
tone is used as the Virtual Tonewheel tone.
• Mono/Poly
• Coarse Tune
• Fine Tune
• Portamento Switch
• Portamento Time
• Attack Time
• Release Time
• Cutoff
• Resonance
• Decay Time
Turning the Controllers in Each
Zone On and Off
Parameter
Description Value
Dp
Damper pedal ON, OFF
F1 Pedal connected to the FC1 jack
F2 Pedal connected to the FC2 jack
PB Pitch Bender
Md Modulation Lever
UP1 Control Slider (UP1)
UP2 Control Slider (UP2)
LW1 Control Slider (LW1)
LW2 Control Slider (LW2)
Making Tone Settings
(Tone Info)
How to Make Settings
RD-700SX_e.book 70 ページ ２００６年３月２３日 木曜日 午後２時５２分