Filter
Top Products
144
Effect/Parameter List
The RD-700SX’s Chorus effect unit can also be used as a stereo delay
unit.
0: OFF
Neither Chorus or Delay is used.
1: CHORUS
2: DELAY
3: GM2 CHORUS
note
(*)
:
fig.MFX-note2e
Chorus Parameter
Parameter Value Description
Filter Type OFF, LPF,
HPF
Type of filter
OFF
: no filter is used
LPF
: cuts the frequency range above the
Cutoff Freq
HPF
: cuts the frequency range below
the Cutoff Freq
Cutoff Freq 200–8000 Hz Basic frequency of the filter
Pre Delay 0.0–100.0 ms Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00
Hz
Frequency of modulation (Hz)
Rate ( )
note (*) Frequency of modulation (note)
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback 0–127 Adjusts the amount of the chorus sound
that is fed back into the effect.
Parameter Value Description
Delay L Mode ms, note When this is set to “note,” the effect is
synchronized with the tempo.
Delay L (ms) 0–1000 ms Adjusts the time until the delay sound is
heard. (Hz)
Delay L ( )
note (*) Adjusts the time until the delay sound is
heard. (note)
Delay R Mode ms, note Settings of the Delay R
The parameters are the same as for the
Delay L.
Delay R (ms) 0–1000 ms
Delay R ( )
note (*)
Delay C Mode ms, note Settings of the Delay C
The parameters are the same as for the
Delay L.
Delay C (ms) 0–1000 ms
Delay C ( )
note (*)
Center Feedbak -98–+98 % Adjusts the proportion of the delay sound
that is fed back into the effect. Negative (-)
settings will invert the phase.
HF Damp 200–8000
Hz,
BYPASS
Adjusts the frequency above which sound
fed back to the effect will be cut. If you do
not want to cut the high frequencies, set
this parameter to BYPASS.
Left Level 0–127 Volume of each delay sound
Right Level 0–127 Volume of each delay sound
Center Level 0–127 Volume of each delay sound
Parameter Value Description
Pre-LPF 0–7 Cuts the high frequency range of the
sound coming into the chorus.
Higher values will cut more of the high
frequencies.
Level 0–127 Volume of the chorus sound
Feedback 0–127 Adjusts the amount of the chorus sound
that is fed back into the effect.
Delay 0–127 Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate 0–127 Frequency of modulation
Depth 0–127 Depth of modulation
Send To
Reverb
0–127 Adjusts the amount of chorus sound that
will be sent to the reverb.
(Double note)(Dotted whole note),
(Dotted half note),
(Dotted thirty-second note),
(Whole note),
(Double-note triplet),
(Sixteenth-note triplet),
(Thirty-second note),
(Sixty-fourth-note triplet), (Sixty-fourth note), (Thirty-second-note triplet),
(Dotted eighth note),(Quarter-note triplet),(Eighth note),
(Half-note triplet),(Quarter note),
(Dotted quarter note),
(Whole-note triplet),
(Half note),
(Sixteenth note),
(Eighth-note triplet),
(Dotted sixteenth note),
RD-700SX_e.book 144 ページ ２００６年３月２３日 木曜日 午後２時５２分