Filter
Top Products
118
Effect/Parameter List
25: STEP FLANGR (STEP FLANGER)
This is a flanger in which the flanger pitch changes in steps. The speed
at which the pitch changes can also be specified in terms of a note-
value of a specified tempo.
26: HEXA-CHORUS
Uses a six-phase chorus (six layers of chorused sound) to give richness
and spatial spread to the sound.
27: TREMOLO CHO (TREMOLO CHORUS)
This is a chorus effect with added Tremolo (cyclic modulation of
volume).
28: SPACE-D
This is a multiple chorus that applies two-phase modulation in stereo.
It gives no impression of modulation, but produces a transparent
chorus effect.
Assignable Parameters
MFX Control StepRate, Depth, Feedback, Balance
Parameter Value Description
Filter Type OFF,
LPF,
HPF
Type of filter
OFF
: No filter is used
LPF
: Cuts the frequency range above
the Cutoff Freq
HPF
: Cuts the frequency range below
the Cutoff Freq
Cutoff Freq 200–8000 Hz Basic frequency of the filter
Pre Delay 0.0–100.0 ms Adjusts the delay time from when the
direct sound begins until the flanger
sound is heard.
Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00
Hz
Frequency of modulation (Hz)
Rate ( )
note (*1) Frequency of modulation (note)
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback -98– +98 % Adjusts the proportion of the flanger
sound that is fed back into the effect.
Negative (-) settings will invert the
phase.
Step Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
StepRate(Hz) 0.10–20.00
Hz
Rate (period) of pitch change (Hz)
Step Rate
()
note (*1) Rate (period) of pitch change (note)
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Balance D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the flanger sound (W)
Level 0–127 Output Level
Assignable Parameters
MFX Control Depth, Rate, Balance
Parameter Value Description
Pre Delay 0.0–100.0 ms Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00
Hz
Frequency of modulation (Hz)
Rate ( )
note (*1) Frequency of modulation (note)
Depth 0–127 Depth of modulation
Pre Delay
Deviat
0–20 Adjusts the differences in Pre Delay
between each chorus sound.
Depth
Deviation
-20– +20 Adjusts the difference in modulation
depth between each chorus sound.
Pan Deviation 0–20 Adjusts the difference in stereo location
between each chorus sound.
0
: All chorus sounds will be in the
center.
20
: Each chorus sound will be spaced
at 60 degree intervals relative to the
center.
Balance D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level
Assignable Parameters
MFX Control Chorus Depth, Cho Rate, Trm Rate, Balance
Parameter Value Description
Pre Delay 0.0–100.0 ms Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Cho Rate(Hz) 0.05–10.00
Hz
Modulation frequency of the chorus
effect (Hz)
Cho Rate
()
note (*1) Modulation frequency of the chorus
effect (note)
Chorus Depth 0–127 Modulation depth of the chorus effect
Treml Rate
Mode
Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Trm Rate(Hz) 0.05–10.00
Hz
Modulation frequency of the tremolo
effect (Hz)
Treml Rate
()
note (*1) Modulation frequency of the tremolo
effect (note)
Treml
Separation
0–127 Spread of the tremolo effect
Treml Phase 0–180 deg Spread of the tremolo effect
Balance D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the tremolo chorus
sound (W)
Level 0–127 Output Level
Assignable Parameters
MFX Control Depth, Rate, Balance
Parameter Value Description
Pre Delay 0.0–100.0 ms Adjusts the delay time from the direct
sound until the chorus sound is heard.
Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00
Hz
Frequency of modulation (Hz)
Rate ( )
note (*1) Frequency of modulation (note)
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Balance D100:0W–
D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level 0–127 Output Level
Parameter Value Description
RD-700SX_e.book 118 ページ ２００６年３月２３日 木曜日 午後２時５２分