Filter
Top Products
127
Chapter 7 Saving a Sound You Create
Chapter 7
1. Insert the memory card containing the files you want to
copy into the slot, then press [Enter].
fig.7-20a
2. Rotate the VALUE dial to select the file that will be
copied, and then press [ENTER].
fig.7-20b
3. When the display shown above appears, insert the copy
destination card and press [ENTER].
4. Press [ ] or [ ] to move the cursor, and then
create the name by turning the VALUE dial or pressing
the [INC] or [DEC] buttons to select the desired
characters (up to 8 characters). For more detailed
information, refer to Step 4 of “Transmitting to a
Memory Card (Save)” (p. 125).
fig.7-20c
5. Press [ENTER] to execute the File Copy, and the
following display will appear.
fig.7-20d
When repeating the copy procedure with another file or
other data, press [ENTER]. To exit the operation, press
[EXIT].
Checking the Contents of Memory Card (INFO)
You can view the number of files on a memory card, its
remaining free memory, and the size of each file. You can
also change and delete registration of groups (CD-A through
CD-H).
fig.7-21
Pressing [A]–[H] in this window displays the files registered
to the applicable group. The display does not change if there
is no data registered to the group corresponding to the
button pressed.
Pressing [SHIFT] switches the display to the display shown
in the figure below.
fig.7-22
The registerd group will be indicated as “*.”
• Changing Groups
Rotate the VALUE dial to select the source file to be
changed. Hold down [SHIFT] and press one of the
buttons [A]–[H] to substitute the files for the files
registered in the applicable group.
• Deleting Groups
Rotate the VALUE dial to select the file to be deleted.
Hold down [SHIFT] and press [UNDO] to execute the
deletion of the group.
Transmitting Data to an External
MIDI Device (XFER)
You can transmit sound generator or System settings that are
in the XV-3080’s memory – or stored on a memory card – to
an external MIDI device or to the XV-3080’s USER memory.
Transmitting to an External MIDI
Device
The act of transmitting Patch, Performance, Rhythm Set or
System data to an external MIDI device is called a “bulk
dump.” You can perform a bulk dump when two XV-3080s
are connected to each other, or when you wish to store Patch,
Performance, Rhythm Set or System data on an external
MIDI device as a safety backup of your XV-3080 data.
fig.7-23.e
While data is being transmitted, the following display will
appear.
fig.7-24
To cancel data transmission, press [EXIT].
Data type
Source block
Destination