Filter
Top Products
59
Chapter 2 Using the XV-3080 Effects
Chapter 2
Keysync (Keysync Switch)
Determines whether the Flanger LFO is reset according to the
input sound (ON) or not (OFF).
Thre (Keysync Threshold)
Adjust the volume level for which reset will be applied.
Keysync Phase
Sets the LFO phase when the LFO is reset.
LowGain
Adjust the low frequency range gain (amount of boost or
cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance #
Adjusts the volume balance between the direct sound and
the flanger sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W the flanger sound will
be output.
Level (Output Level) 0–127
Adjust the output level.
43:FORMANT FILTER
This adds a vowel character to the sound, making it similar
to a human voice.
Drive
Turns Drive on/off.
Specifies the depth of distortion. The volume will change
together with the degree of distortion.
Vowel
Selects the vowel. The left setting is the vowel 1. The right
setting is the vowel 2.
Rate
Sets the frequency at which the two vowels will be switched.
Depth
Sets the effect depth.
Keysync Sw (KeySync Switch)
Determines whether the LFO for switching the vowels is
reset according to the input sound (ON) or not (OFF).
Threshold (Keysync Threshold)
Specifies the volume level for which reset will be applied.
Manual
Sets the point at which the two vowels will be switched.
When set to 50, Vowels 1 and 2 switched in the same amount
of time. Setting this higher than 50 increases the time for
Vowel 1; setting this lower than 50 decreases the time for
Vowel 1.
Low Gain
Specifies the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain
Specifies the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Pan (Output Pan)
Specifies the stereo location of the output sound. L64 is far
left, 0 is center, and 63R is far right.
Level (Output Level)
Specifies the output volume.
Formant
2-Band
EQ
L in
R in
Overdrive
L out
R out
Pan R
Pan L