Filter
Top Products
51
Chapter 2 Using the XV-3080 Effects
Chapter 2
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
pitch shift sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
pitch shift sound will be output.
Level (Output Level)
Adjust the output level.
24: REVERB
The Reverb effect adds reverberation to the sound,
simulating an acoustic space.
fig.2-30
Type (Reverb Type)
Select the type of Reverb effect.
ROOM1:dense reverb with short decay
ROOM2:sparse reverb with short decay
STAGE1:reverb with greater late reverberation
STAGE2:reverb with strong early reflections
HALL1:reverb with clear reverberance
HALL2:reverb with rich reverberance
Pre Dly (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the reverb sound is heard.
Time (Reverb Time) #
Adjust the time length of reverberation.
HF Damp
Adjust the frequency above which the reverberant sound will
be cut. As the frequency is set lower, more of the high
frequencies will be cut, resulting in a softer and more muted
reverberance. If you do not want the high frequencies to be
cut, set this parameter to BYPASS.
LowGain
Adjust the gain of the low frequency range.
Hi Gain
Adjust the gain of the high frequency range.
Balance (Effect Balance) #
Adjust the volume balance between the direct sound and the
reverb sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
reverb sound will be output.
Level (Output Level)
Adjust the output level.
L in
R in
L out
R out
Reverb
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
2-Band
EQ