Filter
Top Products
25
Chapter 2 Using the XV-3080 Effects
Chapter 2
Fbk
When the Type setting is DELAY or PAN-DLY, this adjust
the amount of delay feedback, controlling the number of
delay repeats.
Higher values result in more repeats.
*1 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000,
2500, 3150, 4000, 5000, 6300, 8000 Hz, BYPASS
For BRIGHT ROOM/BRIGHT HALL/
BRIGHT PLATE
Pre Delay (Pre Delay Time) 0.0–100 ms
This specifies the time between when the original sound is
heard and the moment at which the reverb is first heard.
Time (Reverb Time) 0–127
This sets the reverb length.
Size 1–8
This adjusts the size of the simulated room or hall. The size
becomes bigger as the value increases.
High Cut (High Cut Frequency) *1
This sets the frequency above which the high-frequency
content of the reverb will be reduced. If you do not want to
reduce the brightness of the reverb, set this parameter to
BYPASS.
Density (Reverb Density) 0–127
This adjusts the density of reverb. Higher values result in
greater density.
Diffusion (Reverb Diffusion) 0–127
This adjusts the change in the density of the reverb over time.
The higher the value, the more the density increases with
time. The effect of this setting is most pronounced with long
reverb times.
LF Damp Frequency *2
This specifies the frequency below which the low-frequency
content of the reverb sound will be reduced, or “damped.”
LF Damp Gain -36–0 dB
This adjusts the amount of damping applied to the frequency
range selected with LF Damp. With a setting of “0,” there
will be no reduction of the reverb’s low-frequency content.
HF Damp Frequency *3
This specifies the frequency above which the high-frequency
content of the reverb sound will be reduced, or “damped.”
HF Damp Gain -36–0 dB
This adjusts the amount of damping applied to the frequency
range selected with HF Damp. With a setting of “0,” there
will be no reduction of the reverb’s high-frequency content.
*1 160, 200, 250, 320, 400, 500, 640, 800, 1000, 1250, 1600,
2000, 2500, 3200, 4000, 5000, 6400, 8000, 10000, 12500 Hz,
BYPASS
*2 50, 64, 80, 100, 125, 160, 200, 250, 320, 400, 500, 640, 800,
1000, 1250, 1600, 2000, 2500, 3200, 4000 Hz
*3 4000, 5000, 6400, 8000, 10000, 12500 Hz
PATCH REV OUT (Patch Reverb Output)
Output Assign (Reverb Output Assign) A/B/C
This setting allows you to specify the pair of OUTPUT jacks
to which the stereo output of the Reverb is routed.
Level (Reverb Level) 0–127
This specifies the output level of the Reverb.