Filter
Top Products
60
Chapter 2 Using the XV-3080 Effects
44:RING MODULATOR
Ring Modulator is an effect which applies amplitude
modulation (AM) to the input signal, producing bell-like
sounds.
You can also change the modulation frequency according to
the volume of the sound input to the effects device.
fig.2-54
Freq (Frequency) #
Sets the frequency at which modulation will be applied.
Mod (Modulator)
Selects the input of the source sound for the envelope
controlling the modulation.
When set to Source, the frequency is modulated according to
the envelope of the sound input to the multi-effects.
Mon (Modulator Monitor)
Determines whether the input sound used as the modulator
is output (ON) or not (OFF).
Sens #
Sets the amount of frequency modulation applied.
Pol (Polarity )
Determines whether the frequency modulation moves
towards higher frequencies (UP) or lower frequencies
(DOWN).
LowGain
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W the effect sound will
be output.
Level (Output Level)
Adjust the output level.
45:MULTI TAP DELAY
The Multi Tap Delay has four delays. Each of the Delay Time
parameters can be specified as a note length of the selected
tempo. You can also set the panning and level of each delay
sound.
fig.2-55
Delay 1 (Delay Time 1)
Adjust the delay time from the original sound until the delay
1 sound is heard.
Delay 2 (Delay Time 2)
Adjust the delay time from the original sound until the delay
2 sound is heard.
Delay 3 (Delay Time 3)
Adjust the delay time from the original sound until the delay
3 sound is heard.
Delay 4 (Delay Time 4)
Adjust the delay time from the original sound until the delay
4 sound is heard.
Pan 1 (Output Pan 1)
Sets the stereo position of the delay sound (Delay 1). A
setting of L64 is far left, 0 is center, and 63R is far right.
Pan 2 (Output Pan 2)
Sets the stereo position of the delay sound (Delay 2). A
setting of L64 is far left, 0 is center, and 63R is far right.
Pan 3 (Output Pan 3)
Sets the stereo position of the delay sound (Delay 3). A
setting of L64 is far left, 0 is center, and 63R is far right.
an 4 (Output Pan 4)
Sets the stereo position of the delay sound (Delay 4). A
setting of L64 is far left, 0 is center, and 63R is far right.
Level 1
Adjust the output level of delay 1.
Level 2
Adjust the output level of delay 2.
L in
R in
L out
R out
Ring Mod
2-Band EQ
2-Band EQ
Ring Mod
L in
R in
L out
R out
Multi Tap Delay
Balance W
Balance D
Balance W
Balance D
Delay 1
Delay 3
Delay 4
Delay 2
Feed
back
2-Band
EQ
2-Band
EQ