Filter
Top Products
74
Chapter 3 Selecting Output Jacks
PARALLEL: Sounds are routed to output jacks according to
their output settings.
* The XV-3080’s Master Level and Mix/Parallel settings are
each established using a single global parameter.
Example of Settings
Assigning Different Output
Destinations for the Tones in a Patch
In this example, let’s suppose we have a Patch composed of
four Tones, and we are outputting Tone 1 from the A
OUTPUT jacks, Tone 2 from the B OUTPUT jacks, Tone 3
from the INDIVIDUAL 5 jack, and Tone 4 from the
INDIVIDUAL 6 jack.
The Chorus and Reverb are output from the B OUTPUT
jacks.
First, set the output destination for each Tone.
1. Select the Patch you wish to use.
2. Press [EFFECTS] so that its indicator lights.
3. Press [ ] / [ ] to choose the OUTPUT page.
4. Use TONE SELECT [1]–[4] to select the Tone you wish to
set up.
5. Press [ ] / [ ] to move the cursor to the
parameter you wish to set, and turn the VALUE dial or
press [INC] / [DEC] to select the following values.
Output Assign Chorus Reverb
Tone 1 OUTPUT A:127 100 100
Tone 2 OUTPUT B:127 100 100
Tone 3 INDIV 5:127 100 100
Tone 4 INDIV 6:127 100 100
The Chorus and Reverb send levels can be set to any value
you wish other than 0.
6. Press [COMMON] to make its indicator light.
7. Use [ ] / [ ] to select the PATCH COMMON page.
8. Press [ ] / [ ] to move the cursor to Output
Assign.
9. Turn the VALUE dial or press [INC] / [DEC] to select
TONE.
Next, select the Chorus output destination and set its
overall level.
1. Press [EFFECTS] so that its indicator lights.
2. Press [ ] / [ ] to select the PATCH CHO OUT page.
3. Press [ ] / [ ] to move the cursor to Output
Assign.
4. Turn the VALUE dial or press [INC] / [DEC] to select B.
5. Press [ ] / [ ] to move the cursor to Level.
6. Turn the VALUE dial to select 100.
7. Press [ ] / [ ] to move the cursor to Select.
8. Either rotate the VALUE dial or press [INC] / [DEC] to
set it to MAIN.
Finally, select the Reverb output destination and set its
overall level.
1. Press [ ] / [ ] to select the PATCH REV OUT page.
2. Press [ ] / [ ] to move the cursor to Output
Assign.
3. Turn the VALUE dial or press [INC] / [DEC] to select B.
4. Press [ ] / [ ] to move the cursor to Level.
5. Turn the VALUE dial to select 100.
6. Press [EXIT] to return to the PATCH PLAY page.